This kit is only good for one test so if you mess up, the results will be invalid. The most important step when doing the water test is to only fill the vial with ONE pipette full of the water sample. I was tempted to fill the vial the easy way by putting it directly into the water stream from the faucet, fortunately for whatever reason I decided to reread the instructions which states to only use one pipette full of the water sample being tested. The test takes about 4 minutes for the results to fully appear. You basically put the test strip into the vial containing the water sample and just let it sit there undisturbed for 4 minutes. In my test the results were very clear and was negative.As far as testing water for lead, this product seems to do a good job. If one follows the instructions correctly (ie. you don''t need to load the sample vile with very much water), this product is almost fool proof. I say almost because it can be difficult to read the difference between a positive and negative result the way the colour system works.
Buy WaterSafe Water Test Kit for Lead Now
This is a single lead test stick. It likely cost $0.10 to make. Yet they charge $11 and -worst of all -it simply doesn''t work. They have three possible outcomes: 1) no lead; 2) lead; and 3) sorry -didn''t work. But no refund policy and no replacement.Short story, shorter: don''t buy it.This test is the best i found because the results are instant (well with in a few minutes). So many of the tests I looked at buying in stores were the type where you had to swab the test surface and then mail the swab to a lab, pay a $10 lab fee, and get your results weeks later. This instant test is so much easier and faster.Worked fine, easy to use, no problems. Would recommend. Just make sure you follow the directions as indicated, especially with the pipette.
0 comments:
Post a Comment