Pentek HD-950-34 Whole House Filter System Save 20% Off

• Ametek/Pentek Filter Housings
• 10" Big Blue Housing, Blue/Black 3/4" w/ Pressure Relief

This housing seems very heft and seems very durable. It is also quite heavy, so I thought it was a good idea to get the mounting bracket to screw it to the wall. I was a little afraid to hang it from my pipes only.

There are holes up top for a mounting bracket, but this is something extra you need to buy. When I bought my bracket it came with all the screws I needed to put it on this housing and screw it to the wall.

There is no filter that comes with this either. This is fine, and I expected it, but just wanted to let you know. I used a DGD-5005 filter. These are great, and are a 50 micron and 5 micron filter, so it is just like putting 2 filters in with this one housing.

I also found it wasn''t a bad idea to get a SW-3 wrench to open up this housing. It is a plastic handle that makes it a lot easier to unscrew the filter to change it. My advice is DON''T TIGHTEN THE FILTER UP WITH THE FILTER WRENCH. It was VERY hard to open the filter again later and change it when I tightened it with the wrench. Only use the wrench to open it, not tighten it.

Overall a great product, does its just, and I think it should keep lasting me a long time.

Buy Pentek HD-950-34 Whole House Filter System Now

Well made and works well. I use the (Point 5) Micron filter. I change the filter every 6 months. I Use a little Vaseline(very little thinned out)around the threads to remove easily. Also apply to the O ring for better seal. The description clearly sates housing only, so purchase your filter separately. If your water source is very dirty, use a pre-filter. I kind of like the Point 6 micron for whole house. IF you are serving two bedrooms the .5 and .6 will work. Make sure you know your GPM. You may have to bump up to 4.5 x 20.

Hope this helps.

Read Best Reviews of Pentek HD-950-34 Whole House Filter System Here

This item does NOT come with a filter, filter cost are an additional $20.00 to $25.00, Also the pre-drilled holes for mounting a flange bracket to are NOT tapped (NOT threaded) nor did it come with any bolts to mount to a flange.